Blowing Blub

WHAT DOES IT MEAN WHEN LIGHT BULBS KEEP BLOWING

Relax!!! This problem does not mean you have a major wiring fault. This is a never-ending problem which has been looked into for donkey’s years. A wiring fault in your circuit will be picked up by fuses and MCB’s long before it gets to the bulb.

What can Cause a Bulb to Blow?
There are a few reasons bulbs can blow, the major one being cheaper bulbs. The elements in cheap bulbs are much thinner and any surge of power, however slight, simply breaks them. Always go for more expensive, better quality light bulbs, its cheaper in the long run.

A loose connection in the lamp holder can also cause bulbs to blow. This is because the circuit is not completed as tightly as it could be and the electricity may have cause to “arc” or jump across the contact, rather than simply flowing through it. When this happens it produces more heat in the fitting that is expected or catered for by the bulb, and the bulb can blow.

The same can happen if the spring loaded connection in the bulb holder is slightly loose. This will cause electricity to arc across the contact, cause too much heat and blow the bulb. This can very often be diagnosed by looking at the contact on the bottom of the bulb to see if it is pitted.

Arcing electricity effectively melts the metal it is arcing onto ( This is how arc welding works) so if the bulb contact is being subjected to arcing, tiny little indentations occur, called pitting.

It is sometimes possible, if the live connection in your light switch is a little loose, for this to happen here also. Heat will be generated and it is possible, though very very remote, for the bulb to blow as a result of this.

What Happens When a Bulb Blows?
When a bulb blows, 99% of the time the fuse for the lighting circuit will blow or trip also. This makes the problem seem rather bigger than it actually is.

The reason for a blowing lamp tripping an MCB is that the lamp element gets thinner during its life to the point where it breaks at the thinnest point, this point will melt just before failure. The resistance of the overheating element will momentarily be very low and a current surge is caused, this is picked up by MCB’s but generally not fuses.

Blowing Bulb Checklist
So, three things to look into if your bulbs keep blowing:

  1. Your bulb supplier
  2. The wire connections inside your bulb holder
  3. If the spring-loaded connectors are working properly inside the bulb holder

As a last resort, you can also check the tightness of the connections in your switch.
As mentioned above, make sure you have turned the power off before you do any maintenance whatever.

How to Stop LED Bulbs Blowing
Now that more and more bulbs are LED or low energy bulbs, they don’t have a filament to blow as described above. Assuming that you have not bought really cheap bulbs, and they keep blowing then there are other problems that are the cause.

There are a number of potential issues that could be the case here. Constantly blowing lamps and/or fuses could be:

 

  • Bad/loose connections causing arcing etc….
  • Cross connection of either conductor somewhere in the circuit
  • Overcurrent – i.e. too much current in the circuit. Usually caused by an incorrect fuse or miniature circuit breakers somewhere in the circuit
  • Degraded or damaged wiring. Either through age, furry critters or mechanical damage (e.g. picture hook, stray screw or nail)

If you have ruled out a loose fitting or connection in your bulb holder, then we recommend that you get a qualified and registered electrician to conduct a full check of the lighting circuit(s) and any other circuits with similar issues.

Comments are now closed.